Flat panel in rolls in expanded PE (alternative to EPS panel), with a height of just 6 mm (a particularly valid solution in case of renovations with height constraints), featuring an adhesive base and and also equipped on the top with a film suitable for fixing with a tear-off system, with a laying grid.

The Klettjet system in fact allows the installer a certain level of freedom in laying the circuits (a significant advantage in rooms with irregular layouts), and also speeds up installation times insofar as the pipe is easily fixed to the flat panel by means of the tear-off layer attached to both.
It is therefore no longer necessary to use clips, thus allowing the installer to rectify any laying errors and/or imperfections, removing the pipe from the panel and laying it again in the correct position (this is not possible in the case of pipes fixed to the flat panel via clips).

The Klettjet system for the development of underfloor radiant heating systems is composed of:
- Flat panel in rolls in EPS 150 (expanded polystyrene), with height 20, 30 or 41 mm, with a film suitable for fastening with a tear-off system, with a laying grid
- Flat panel in rolls in expanded PE (alternative to the above panel), with a height of just 6 mm (a particularly valid solution in case of renovations with height constraints), featuring an adhesive base and similarly topped with a film suitable for fastening with a tear-off system, with a laying grid
- PE-Xc pipe, size 16x2, on the surface of which a spiral of hook and loop fastener tape is wound

The system is completed by Emmeti monobloc compression fittings to connect the pipe to the distribution manifold, tape with Velcro to join the rolls of panel, and the necessary tools for correct installation (roll dispenser, pipe support, etc.).
Klettjet satisfies, in a single solution, people’s need for comfort in their own home, and installers’ need for practicality during installation.